RTS MCE-325 A5F
-Programmable Master Station with A5F Headphone Connector

OUR PART #  MCE325/A5F


RTS' MCE-325 is a four-channel, programmable intercom station. It may be used as a headset station or, with the addition of the MCS-325 Modular Speaker, as a speaker station. It may be mounted in a console or equipment rack via optional mounting kits. The MCE-325 can be used with either two-wire or four-wire intercom lines, or a combination of both. In the labeling on the MCE-325, references to channels 1, 2, 3, and 4 indicate two-wire lines; references to four-wire A and four-wire B indicate four-wire lines. The MCE-325 can be interfaced to a variety of external devices including external program sources, two-way radios, paging systems, and satellite circuits.

Features:

  • Call signaling is accomplished using an inaudible (20 kHz) signal to activate a call indicator LED.
  • Remote "talk-off"
    Active, unattended remote station microphones may be deactivated by momentarily injecting an inaudible (24 kHz) signal into the corresponding intercom line. The MCE-325 can send and receive “talk-off” signals.
  • VOX circuit
    The MCE-325 may be programmed for voice activation of the microphone.
  • Simple IFB
    Program audio assigned to a channel is interrupted during talk.
  • External device keying
    External devices, such as two-way radios, speaker mute relays, or paging systems may be activated through key outputs at the auxiliary connector on the rear panel. The key outputs may also be used to expand the simple IFB function, allowing any one of a number of MCE-325 stations to interrupt the program source and talk on the line.
  • Microphone Limiter
    The microphone preamplifier circuit contains a limiter, which helps to equalize voice levels.
  • Fully programmable
    Retains programming even when power is shut off.
  • Instantaneous Auto Reset (IAR), the newest technology in performance and safety, which uses a revolutionary new circuitry that dynamically monitors line fault conditions. Then, when the fault is removed, automatically brings individual power supply channels up.

Specifications:

  • Bridging Impedance (to line): 10,000 ohm typical
  • Noise Contribution to 200 ohm Line: -90 dBu
  • Call Signal Frequency: 20 kHz, crystal controlled
  • Talk-off Frequency: 24 kHz, crystal controlled

Microphone Preamplifier:

  • Maximum Voltage Gain: 54 dB
  • Frequency Response: 100 Hz to 8,000 Hz, ±3 dB
  • Input Impedance: 1,000 ohms
  • Limiter Range: 30 dB

Headphone Amplifier:

  • Maximum Voltage Gain: 30 dB
  • Frequency Response: 100 Hz to 8,000 Hz, ±3 dB
  • Headphone Impedance: 50 to 600 ohms
  • Output Power 150 mW into 50 ohms
  • Output Voltage Level 8 Vp-p

Speaker Amplifier:

  • Maximum Voltage Gain: 30 dB
  • Frequency Response: 100 Hz to 8,000 Hz, ±3 dB
  • Speaker Impedance: 8 to 16 ohm
  • Output Power per Amplifier: 5W into 8 ohms
  • Output Voltage Level: 16 Vp-p

Power and Mechanical:

  • Power Requirements: 115 or 230 VAC, 20 VA max version available
    12 to 25 VDC, 100 to 125 mA quiescent, 900 mA max
  • Dimensions: 1.72" (44 mm) tall, 8.2" (208 mm) wide, 8" (203 mm) deep
  • Weight: 4.5 lbs (1.93kg)
  • Material/Finish Thermo-plastic front panel, aluminum case, light gray finish

Connectors:

  • Intercom Line Connector: XLR type, 3-pin (male-female loop through on two-wire
  • Channel 1 and 2, or four-wire channel A; Female only on two-wire channel 3 and 4, or four-wire channel B
  • Dynamic Mic: XLR type, 6-pin female
  • Carbon Mic: 1/4" phone jack, 3-circuit
  • Auxiliary Connector: 25-pin, female, D-Sub
  • Program Input:s 1/4" phone jack, 3-circuit
  • Speaker Output: 1/4" phone jack, 3-circuit
  • Panel Mic: 1/4" phone jack, metal busing, 3-circuit
Telex HR2R5-300534-002 Noise-Reduction Headset, A5M Connector

Telex HR2R5-300534-002 Noise-Reduction Headset, A5M Connector

The HR-2 is a dual-sided, medium-weight passive noise reduction headset with dynamic noise canceling microphone. the headset has a noise reduction rating of 21 dB; suitable for use in a moderately noisy environment. The ergonomic headband ...
Log In For Price
In Stock
Telex PH88R5 Single-sided Lightweight Headset, A5M Connector

Telex PH88R5 Single-sided Lightweight Headset, A5M Connector

Super light-weight single muff headset with dynamic noise canceling microphone. Semi-rigid, fully adjustable gooseneck mic boom for precise positioning. High quality wide band earphones with moleskin covering for better fit, isolation and ...
Log In For Price
Usually ships in 7-14 business days.
RTS MCP1 Mounting Hardware

RTS MCP1 Mounting Hardware

Dual rack mount kit, two main components side by side. For the SSA-324/424 intercom interfaces.
Log In For Price
In Stock
RTS MCP-2 Single Rackmount Kit for SSA-324, SSA-424

RTS MCP-2 Single Rackmount Kit for SSA-324, SSA-424

RTS' MCp-2 is a rackmount kit for one main (modular style) component.  Mounting brackets are the key to the RTS modular user station design concept.  By choosing the appropriate mounting kit individual user stations can be ...
Log In For Price
In Stock
RTS BP-351 A5F 2-Channel Portable Beltpack with A5F Headphone Connector

RTS BP-351 A5F 2-Channel Portable Beltpack with A5F Headphone Connector

RTS' BP-351 is a portable user station for use with RTS™ Two-Wire intercom systems.  The BP-351 is a microprocessor controlled two-channel select intercom belt pack. The BP-351 has a connection for headset/earset ...
Log In For Price
Usually ships in 7-14 business days.
RTS MCS-325 5W Passive Modular Speaker

RTS MCS-325 5W Passive Modular Speaker

RTS' MCS-325 is a modular passive general purpose monitor speaker.  It can be combined with MCE-325 and MRT-327 to provide speaker station operation, for example.  Packaged in 1/2 rack by 1 RU metal housing for added ...
Log In For Price
Usually ships in 7-14 business days.
Telex PH1R5 Single Headset w/Mic 64438103, A5M 5-pin RTS connector

Telex PH1R5 Single Headset w/Mic 64438103, A5M 5-pin RTS connector

Medium-weight single muff headset with foam filled cushions offers a light feel with moderate isolation from ambient noise. Dynamic noise canceling mic is easily positioned with unique continuously adjustable ball joint.
Log In For Price
Usually ships in 7-14 business days.

Click to download

Add to Cart

We're sorry, only of this item available



Call a Sales Pro at for more information

Serving Contractors, Dealers, and Installers Since 1977

Contact: 1-800-828-0509 / Hours: Mon - Fri 7:00AM - 7:00PM