The Furman Merit M-8S Power Sequencer is a great low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.
NOTE: This is a RESTOCK item that has had its box opened or has been repackaged. It may have minor cosmetic flaws and may have been sold to a customer and returned. Please contact your Sales Pro for more information on this and other products.
Power Sequencing - Prevents excessive inrush currents.
Noise Filtration - Noise filtering to reduce radio frequency and electromagnetic interference.
Surge Protection - Ensures equipment stays safe.
9 Total Outlets - Eight rear panel outlets and one front panel convenience panel outlet.
15 Amp Rating - 15 amp rating, with circuit breaker.
"Protection OK" Indicator - Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
Wall Wart Spacing - Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
Furman M-8S Features:
- Standard level AC protection and filtering
- Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
- Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
- All settings and configurations available on rear panel
- Three year limited warranty
Furman M-8S Specifications:
- Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)
- Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
- AC Receptacles:
- Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R
- Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex), 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
- Standard level AC Surge Protection: Merit Class (sacrificial)
- Spike Protection Mode: Line to neutral, zero ground leakage
- Max Continuous Operating Voltage: 130V RMS
- Max Clamp Voltage: 500 Volts Peak
- Peak Impulse Current: 12,000 Amps
- Energy Rating (2 X 820¼S): 225 Joules
- AC Filtering: Standard level Pi LCR Filter
- Noise Attenuation: >26dB, 100 Khz to 1 MHz
- Operating Temperature Range: 40°F - 105°F (5°C - 40°C)
- Humidity Range: <90% rH (Relative Humidity)
- Rocker Switch: Front panel, Sequence (ON, OFF)
- Thermal Circuit Breaker: Front panel, push to reset
- Front Panel Indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK
- Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
- Potentiometer: Rear panel, time calibration fine tune delay adjust
- Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
- Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
- Dimensions (LxDxH): 19" x 8.75" x 1.75"
- Weight: 7 lbs.
- Power Consumption: 5 Watts
- Safety Agency: C/CSA/US
