Blue Sky EXO2
Stereo Monitoring System, 2 Satellite Speakers, 1 Subwoover and Desktop Controller

OUR PART #  EXO2


Includes:

  • 2 x Satellite Speakers
  • 1 x Subwoofer
  • Desktop Controller

EXO2 is an evolution of the original EXO stereo monitoring system. As with the original EXO, it combines true, full range monitoring with the convenience of a desktop remote control hub. However, in order to allow the subwoofer to more easily integrate into even the most compact workspace, the EXO sub has been greatly reduced in size. The original EXO sub was approximately a 14" cube, the new SUB is much smaller (10"H x 9"W x 11"D) and yet still has much the same performance of the original EXO system.

General Specifications

  • Input Impedance:
    XLR/TRS Combo: 60k ohms balanced, Input gain = +0dBu
    RCA Input: 30k ohms unbalanced
    3.5mm (front panel input): 15k ohms unbalanced
  • Common Mode Rejection Ratio: 40dB typical @ 60Hz (balanced inputs only)
  • Maximum Input Level:
    +18dBu XLR/TRS/RCA; Input gain = +0dBu
    +12dBu 3.5mm/mini-jack (front panel input)
  • Voltage Sensitivity:
    200mV = 90dB SPL @ 1m XLR/TRS (input gain = 0dBu)
    200mV = 90dB SPL @ 1m RCA
    200mV = 96dB SPL @ 1m 3.5mm (front panel input)
    Note: 200mV = -11.75dBu = -14dBV

Amplifier Power Output (Note: All power output measurements made with the speaker protection circuits disabled. Long term power output is limited by the speaker protection circuitry.)

  • Short term power output 1 channel driven: 42W x 1 @ <.1% THD into 4 ohms @ 1kHz
  • Short term power output 2 channels driven: 35W x 2 @ <.1% THD into 4 ohms @ 1kHz
  • Subwoofer power output: 110W x 1 @ <1% THD into 4 ohms @ 50Hz
  • 3.5mm headphone output: 4 mW x 2 @ <.2% THD into 16 ohms @ 1kHz
  • Mains Voltages: 115V/60Hz
  • Maximum Power Consumption: 240W
  • Fuse Type and Rating: 115V = 5 x 20mm, T 2 Amp 250V (time delay)

Satellite Specifications

  • The single 1/4" x 20 insert on the back of the eXo2 SAT is compatible with OmniMount's type 10 series of wall/ceiling brackets.
  • Dimensions (H x D x W): 7.2" x 4.8" x 5"
  • Weight: 3 lbs
  • 3" cast frame woofer, Neodymium motor structure
  • 1" fabric Neodymium tweeter
  • Fully video shielded
  • Satellite Low Frequency Crossover: 140Hz
  • Tweeter Crossover Frequency: 2200Hz
  • Nominal SAT Impedance: 4 ohms
  • Frequency Response (using eXo2 amplifier):
    +/-2.0dB 200Hz to 10kHz
    +/-3.0dB 140Hz to 20kHz

8" Sealed Box Subwoofer Specifications

  • 8" woofer, vented motor, paper cone with foam surround
  • Fully video shielded
  • Isolation feet are included
  • Dimensions (H x W x D): 9.4" x 9" x 10.2"
  • Weight: 20 lbs
  • Frequency Response:
    Anechoic Response: 35 to 140 Hz +/-6dB
    Typical In-Room Response: 20 to 200Hz (1500 cubic feet)

Blue Sky EXO2
Stereo Monitoring System, 2 Satellite Speakers, 1 Subwoover and Desktop Controller

OUR PART #  EXO2

Product Information:

Includes:

  • 2 x Satellite Speakers
  • 1 x Subwoofer
  • Desktop Controller

EXO2 is an evolution of the original EXO stereo monitoring system. As with the original EXO, it combines true, full range monitoring with the convenience of a desktop remote control hub. However, in order to allow the subwoofer to more easily integrate into even the most compact workspace, the EXO sub has been greatly reduced in size. The original EXO sub was approximately a 14" cube, the new SUB is much smaller (10"H x 9"W x 11"D) and yet still has much the same performance of the original EXO system.

General Specifications

  • Input Impedance:
    XLR/TRS Combo: 60k ohms balanced, Input gain = +0dBu
    RCA Input: 30k ohms unbalanced
    3.5mm (front panel input): 15k ohms unbalanced
  • Common Mode Rejection Ratio: 40dB typical @ 60Hz (balanced inputs only)
  • Maximum Input Level:
    +18dBu XLR/TRS/RCA; Input gain = +0dBu
    +12dBu 3.5mm/mini-jack (front panel input)
  • Voltage Sensitivity:
    200mV = 90dB SPL @ 1m XLR/TRS (input gain = 0dBu)
    200mV = 90dB SPL @ 1m RCA
    200mV = 96dB SPL @ 1m 3.5mm (front panel input)
    Note: 200mV = -11.75dBu = -14dBV

Amplifier Power Output (Note: All power output measurements made with the speaker protection circuits disabled. Long term power output is limited by the speaker protection circuitry.)

  • Short term power output 1 channel driven: 42W x 1 @ <.1% THD into 4 ohms @ 1kHz
  • Short term power output 2 channels driven: 35W x 2 @ <.1% THD into 4 ohms @ 1kHz
  • Subwoofer power output: 110W x 1 @ <1% THD into 4 ohms @ 50Hz
  • 3.5mm headphone output: 4 mW x 2 @ <.2% THD into 16 ohms @ 1kHz
  • Mains Voltages: 115V/60Hz
  • Maximum Power Consumption: 240W
  • Fuse Type and Rating: 115V = 5 x 20mm, T 2 Amp 250V (time delay)

Satellite Specifications

  • The single 1/4" x 20 insert on the back of the eXo2 SAT is compatible with OmniMount's type 10 series of wall/ceiling brackets.
  • Dimensions (H x D x W): 7.2" x 4.8" x 5"
  • Weight: 3 lbs
  • 3" cast frame woofer, Neodymium motor structure
  • 1" fabric Neodymium tweeter
  • Fully video shielded
  • Satellite Low Frequency Crossover: 140Hz
  • Tweeter Crossover Frequency: 2200Hz
  • Nominal SAT Impedance: 4 ohms
  • Frequency Response (using eXo2 amplifier):
    +/-2.0dB 200Hz to 10kHz
    +/-3.0dB 140Hz to 20kHz

8" Sealed Box Subwoofer Specifications

  • 8" woofer, vented motor, paper cone with foam surround
  • Fully video shielded
  • Isolation feet are included
  • Dimensions (H x W x D): 9.4" x 9" x 10.2"
  • Weight: 20 lbs
  • Frequency Response:
    Anechoic Response: 35 to 140 Hz +/-6dB
    Typical In-Room Response: 20 to 200Hz (1500 cubic feet)
Add to Cart

We're sorry, only of this item available



Call a Sales Pro at for more information

Serving Contractors, Dealers, and Installers Since 1977

Contact: 1-800-828-0509 / Hours: Mon - Fri 7:00AM - 7:00PM