Shure MX412S/N
12" Microflex Gooseneck Condenser Microphone with Mute Switch, without Cartridge

OUR PART #  MX412S/N


The Shure MX412S/N Microflex Gooseneck Microphone is fully adjustable and features the ability to add an interchangeable condenser microphone cartridge. Designed for easy replacement, the interchangeable cartridges offer wide frequency response and accurate sound reproduction for a broad variety of applications, such as houses of worship, courtrooms, and conference centers. Plus, the condenser cartridges fit every Microflex model for enhanced convenience and consistent sound. Every Microflex Gooseneck features high sensitivity and a balanced, transformerless output for maximum immunity to electromagnetic hum and RF interference, even over long cable runs.

The microphone cartridge shown on the MX412S/N in the picture above is NOT INCLUDED with purchase.

Includes:

  • MX412S/N Microflex Gooseneck Microphone
  • Flange mount
  • Retainer
  • Isolation Ring
  • Snap-fit foam windscreen
  • Shock Mount
  • Hex Wrench #4

Shure MX412S/N Microflex Gooseneck Microphone Features:

  • Attached XLR preamp
  • Mute switch
  • LED indicator
  • Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
  • Balanced, transformerless output for increased immunity to noise over long cable runs
  • Shock mount that provides over 20 dB isolation from surface vibration noise
  • Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables
Shure MX412S/N Microflex Gooseneck Microphone Specifications:
  • Frequency Response: 50 Hz to 17 kHz
  • Output Impedance (at 1000 Hz): Rated at 150 ? (180 ? actual)
  • Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pa): -33.5 dB (21.1 mV)
  • Maximum SPL (1 kHz at 1% THD, 1 kOhm load): 122.7 dB
  • Equivalent Output Noise (A-weighted): 26.5 dB SPL
  • Signal to Noise Ratio (referenced at 94 dB SPL): 67.5 dB
  • Dynamic Range at 1 kOhm Load: 96.2 dB
  • Common Mode Rejection: 45.0 dB minimum
  • Mute Switch Attenuation (switched models only): 50.0 dB minimum
  • Preamplifier Output Clipping Level (1% THD): –6.0 dBV (0.5 V)
  • Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector.
  • Power Requirements: 11 to 52 Vdc phantom, 2.0 mA
  • Environmental Requirements
    • Operating Temperature Range: –18° C to 57° C (0° F to 135° F)
    • Relative Humidity: 0 to 95%
  • Dimensions
    • Microphone
      • Gooseneck: 12" (30 cm)
      • Head Diameter: 0.46" (11.68 mm)
      • Base Length: 3.86" (98.04 mm)
      • Base Diameter: 0.79" (20.07 mm)
    • Mounting Flange
      • Diameter: 2.62" (66.70 mm)
      • Depth: 0.56" (14.40 mm)
Desktop Microphone Base Stand
Shure A412B Desktop Microphone Base Stand
The Shure A412B microphone base allows gooseneck microphones to be quickly mounted in situations where permanent installation is impractical.  The angled XLR input connector maintains a low profile, while inside the base there is ...
Black Omnidirectional Replacement Cartridge
Shure R183B Black Omnidirectional Replacement Cartridge
Omnidirectional cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 and WL183 microphones.
Supercardioid Cartridge, Black.
Shure R184B Supercardioid Cartridge, Black.
Supercardioid cartridge for WL183, WL184, WL185 and all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 Microphones. 
Cardioid Cartridge, Black.
Shure R185B Cardioid Cartridge, Black.
Cardioid cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 microphones.
Shockmount systems
Shure A400SM Shockmount systems
Recessed shock mount for all Microflex® and Easyflex® gooseneck microphones.The A400SM Shock Mount employs Shure Shock-Stopper TM construction, which decouples the microphone from the mounting surface and reduces the transmission of ...
Locking Metal Windscreen
Shure A412MWS Locking Metal Windscreen
The Shure A412MWS is a locking metal windscreen for Microflex gooseneck microphones.

Usually ships in 7-14 business days.
Need it sooner? Call us!
Snap-Fit Windscreen (4-pack)
Shure RK412WS Snap-Fit Windscreen (4-pack)
The Shure RK412WS is a 4-pack of Snap-fit windscreens for MX412 and MX418.
Replacement Microphone Stand Adapter
Shure A57F Replacement Microphone Stand Adapter
Black Stand Adapter for SM63, SM63L, SM63LB, SM81, VP64A, VP64AL, AMS26 microphones and the WA380 Half Wave Antenna.
Microphone Windscreen, 3/8" Inside Diameter (Black)
WindTech 1400-BLACK Microphone Windscreen, 3/8" Inside Diameter (Black)
Since 1976, WindTech has manufactured the highest quality American made microphone windscreens on the market. They are available in  25  brilliant colors, and a wide variety of shapes and sizes to fit most popular microphones. ...
Windscreen for SM99
Shure A99WS Windscreen for SM99
Large high performance foam windscreen for SM99 and MX400 Series gooseneck microphones.
Microphone Windscreen, 3/8" Inside Diameter (Black)
WindTech 1500-BLACK Microphone Windscreen, 3/8" Inside Diameter (Black)
Since 1976, WindTech has manufactured the highest quality American made microphone windscreens on the market. They are available in  25  brilliant colors, and a wide variety of shapes and sizes to fit most popular microphones. ...

Usually ships in 7-14 business days.
Need it sooner? Call us!

Shure MX412S/N
12" Microflex Gooseneck Condenser Microphone with Mute Switch, without Cartridge

OUR PART #  MX412S/N

Product Information:

The Shure MX412S/N Microflex Gooseneck Microphone is fully adjustable and features the ability to add an interchangeable condenser microphone cartridge. Designed for easy replacement, the interchangeable cartridges offer wide frequency response and accurate sound reproduction for a broad variety of applications, such as houses of worship, courtrooms, and conference centers. Plus, the condenser cartridges fit every Microflex model for enhanced convenience and consistent sound. Every Microflex Gooseneck features high sensitivity and a balanced, transformerless output for maximum immunity to electromagnetic hum and RF interference, even over long cable runs.

The microphone cartridge shown on the MX412S/N in the picture above is NOT INCLUDED with purchase.

Includes:

  • MX412S/N Microflex Gooseneck Microphone
  • Flange mount
  • Retainer
  • Isolation Ring
  • Snap-fit foam windscreen
  • Shock Mount
  • Hex Wrench #4

Shure MX412S/N Microflex Gooseneck Microphone Features:

  • Attached XLR preamp
  • Mute switch
  • LED indicator
  • Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
  • Balanced, transformerless output for increased immunity to noise over long cable runs
  • Shock mount that provides over 20 dB isolation from surface vibration noise
  • Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables
Shure MX412S/N Microflex Gooseneck Microphone Specifications:
  • Frequency Response: 50 Hz to 17 kHz
  • Output Impedance (at 1000 Hz): Rated at 150 ? (180 ? actual)
  • Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pa): -33.5 dB (21.1 mV)
  • Maximum SPL (1 kHz at 1% THD, 1 kOhm load): 122.7 dB
  • Equivalent Output Noise (A-weighted): 26.5 dB SPL
  • Signal to Noise Ratio (referenced at 94 dB SPL): 67.5 dB
  • Dynamic Range at 1 kOhm Load: 96.2 dB
  • Common Mode Rejection: 45.0 dB minimum
  • Mute Switch Attenuation (switched models only): 50.0 dB minimum
  • Preamplifier Output Clipping Level (1% THD): –6.0 dBV (0.5 V)
  • Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector.
  • Power Requirements: 11 to 52 Vdc phantom, 2.0 mA
  • Environmental Requirements
    • Operating Temperature Range: –18° C to 57° C (0° F to 135° F)
    • Relative Humidity: 0 to 95%
  • Dimensions
    • Microphone
      • Gooseneck: 12" (30 cm)
      • Head Diameter: 0.46" (11.68 mm)
      • Base Length: 3.86" (98.04 mm)
      • Base Diameter: 0.79" (20.07 mm)
    • Mounting Flange
      • Diameter: 2.62" (66.70 mm)
      • Depth: 0.56" (14.40 mm)
Desktop Microphone Base Stand
Shure A412B Desktop Microphone Base Stand
The Shure A412B microphone base allows gooseneck microphones to be quickly mounted in situations where permanent installation is impractical.  The angled XLR input connector maintains a low profile, while inside the base there is ...
Black Omnidirectional Replacement Cartridge
Shure R183B Black Omnidirectional Replacement Cartridge
Omnidirectional cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 and WL183 microphones.
Supercardioid Cartridge, Black.
Shure R184B Supercardioid Cartridge, Black.
Supercardioid cartridge for WL183, WL184, WL185 and all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 Microphones. 
Cardioid Cartridge, Black.
Shure R185B Cardioid Cartridge, Black.
Cardioid cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 microphones.
Shockmount systems
Shure A400SM Shockmount systems
Recessed shock mount for all Microflex® and Easyflex® gooseneck microphones.The A400SM Shock Mount employs Shure Shock-Stopper TM construction, which decouples the microphone from the mounting surface and reduces the transmission of ...
Locking Metal Windscreen
Shure A412MWS Locking Metal Windscreen
The Shure A412MWS is a locking metal windscreen for Microflex gooseneck microphones.

Usually ships in 7-14 business days.
Need it sooner? Call us!
Snap-Fit Windscreen (4-pack)
Shure RK412WS Snap-Fit Windscreen (4-pack)
The Shure RK412WS is a 4-pack of Snap-fit windscreens for MX412 and MX418.
Replacement Microphone Stand Adapter
Shure A57F Replacement Microphone Stand Adapter
Black Stand Adapter for SM63, SM63L, SM63LB, SM81, VP64A, VP64AL, AMS26 microphones and the WA380 Half Wave Antenna.
Microphone Windscreen, 3/8" Inside Diameter (Black)
WindTech 1400-BLACK Microphone Windscreen, 3/8" Inside Diameter (Black)
Since 1976, WindTech has manufactured the highest quality American made microphone windscreens on the market. They are available in  25  brilliant colors, and a wide variety of shapes and sizes to fit most popular microphones. ...
Windscreen for SM99
Shure A99WS Windscreen for SM99
Large high performance foam windscreen for SM99 and MX400 Series gooseneck microphones.
Microphone Windscreen, 3/8" Inside Diameter (Black)
WindTech 1500-BLACK Microphone Windscreen, 3/8" Inside Diameter (Black)
Since 1976, WindTech has manufactured the highest quality American made microphone windscreens on the market. They are available in  25  brilliant colors, and a wide variety of shapes and sizes to fit most popular microphones. ...

Usually ships in 7-14 business days.
Need it sooner? Call us!
Add to Cart

We're sorry, only of this item available



Call a Sales Pro at for more information

Serving Contractors, Dealers, and Installers Since 1977

Contact: 1-800-828-0509 / Hours: Mon - Fri 7:00AM - 7:00PM