Shure MX418SE/S
18" Supercardioid Gooseneck Microphone with Switch

OUR PART #  MX418SE/S


The Shure MX418SE/S 18" Gooseneck Condenser Supercardioid Microphone comes with an attached XLR Preamp, Shock & Flange Mount, 10' Side- (or Bottom-) Exit Cable, Snap-Fit Foam Windscreen.

MX400SE Series microphones are miniature gooseneck-mounted electret condenser microphones designed primarily for speech and vocal pickup. Their high sensitivity and broad frequency range make them suitable for recording, as well as sound reinforcement
applications.

The MX400SE series can be screwed onto a mic stand or the supplied 5/8 in. 27-threaded flange. They can be easily changed from side exit to bottom exit to conceal the cabling. All models include an in-line preamplifier, and a 3.66 m (12 ft.) cable.

NOTE: Actual product may vary slightly from picture shown.

Shure MX418SE/S Features:

  • Wide dynamic range and frequency response for accurate sound reproduction
  • Interchangeable cartridges that provide a choice of polar pattern for each application
  • Shock mount provides over 20 dB of isolation from surface vibration noise
  • Snap-fit foam windscreen
  • RF filtering

Shure MX418SE/S Specifications:

  • Type:  Condenser (electret bias)
  • Frequency Response:  50–17000 Hz
  • Polar Pattern:  Supercardioid
  • Output Impedance:  EIA Rated at 150 Ohm (180 Ohm actual)
  • Output Configuration:  Active balanced
  • Sensitivity (at 1 kHz , open circuit voltage):  –34 dBV/Pa (21mV)
    1 Pascal=94 dB SPL
  • Maximum SPL (1 kHz at 1% THD, 1 kOhm load):  123 dB
  • Equivalent Output Noise (A-weighted):  27 dB SPL
  • Signal-to-Noise Ratio (referenced at 94 dB SPL at 1kHz):  68 dB
  • Dynamic Range (1 kOhm load at 1 kHz):  96 dB
  • Common Mode Rejection (10 Hz to 100 kHz):  45 dB minimum
  • Preamplifier Output Clipping Level (1% THD):  –6dBV (0.5 V)
  • Polarity:  Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector.
  • Cable:  3.65 m (12 ft.)
  • Environmental Conditions:
    • Operating Temperature:  -18–57 °C (0–135 °F)
    • Storage Temperature:  -29–74 °C (-20–165 °F)
    • Relative Humidity:  0–95%
  • Power Requirements:  11–52 Vdc phantom, 2.0 mA
Black Omnidirectional Replacement Cartridge
Shure R183B Black Omnidirectional Replacement Cartridge
Omnidirectional cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 and WL183 microphones.
Supercardioid Cartridge, Black.
Shure R184B Supercardioid Cartridge, Black.
Supercardioid cartridge for WL183, WL184, WL185 and all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 Microphones. 
Cardioid Cartridge, Black.
Shure R185B Cardioid Cartridge, Black.
Cardioid cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 microphones.
Shockmount systems
Shure A400SM Shockmount systems
Recessed shock mount for all Microflex® and Easyflex® gooseneck microphones.The A400SM Shock Mount employs Shure Shock-Stopper TM construction, which decouples the microphone from the mounting surface and reduces the transmission of ...
Snap-Fit Windscreen (4-pack)
Shure RK412WS Snap-Fit Windscreen (4-pack)
The Shure RK412WS is a 4-pack of Snap-fit windscreens for MX412 and MX418.
Windscreen for SM99
Shure A99WS Windscreen for SM99
Large high performance foam windscreen for SM99 and MX400 Series gooseneck microphones.
Locking Metal Windscreen
Shure A412MWS Locking Metal Windscreen
The Shure A412MWS is a locking metal windscreen for Microflex gooseneck microphones.

Usually ships in 7-14 business days.
Need it sooner? Call us!

Shure MX418SE/S
18" Supercardioid Gooseneck Microphone with Switch

OUR PART #  MX418SE/S

Product Information:

The Shure MX418SE/S 18" Gooseneck Condenser Supercardioid Microphone comes with an attached XLR Preamp, Shock & Flange Mount, 10' Side- (or Bottom-) Exit Cable, Snap-Fit Foam Windscreen.

MX400SE Series microphones are miniature gooseneck-mounted electret condenser microphones designed primarily for speech and vocal pickup. Their high sensitivity and broad frequency range make them suitable for recording, as well as sound reinforcement
applications.

The MX400SE series can be screwed onto a mic stand or the supplied 5/8 in. 27-threaded flange. They can be easily changed from side exit to bottom exit to conceal the cabling. All models include an in-line preamplifier, and a 3.66 m (12 ft.) cable.

NOTE: Actual product may vary slightly from picture shown.

Shure MX418SE/S Features:

  • Wide dynamic range and frequency response for accurate sound reproduction
  • Interchangeable cartridges that provide a choice of polar pattern for each application
  • Shock mount provides over 20 dB of isolation from surface vibration noise
  • Snap-fit foam windscreen
  • RF filtering

Shure MX418SE/S Specifications:

  • Type:  Condenser (electret bias)
  • Frequency Response:  50–17000 Hz
  • Polar Pattern:  Supercardioid
  • Output Impedance:  EIA Rated at 150 Ohm (180 Ohm actual)
  • Output Configuration:  Active balanced
  • Sensitivity (at 1 kHz , open circuit voltage):  –34 dBV/Pa (21mV)
    1 Pascal=94 dB SPL
  • Maximum SPL (1 kHz at 1% THD, 1 kOhm load):  123 dB
  • Equivalent Output Noise (A-weighted):  27 dB SPL
  • Signal-to-Noise Ratio (referenced at 94 dB SPL at 1kHz):  68 dB
  • Dynamic Range (1 kOhm load at 1 kHz):  96 dB
  • Common Mode Rejection (10 Hz to 100 kHz):  45 dB minimum
  • Preamplifier Output Clipping Level (1% THD):  –6dBV (0.5 V)
  • Polarity:  Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector.
  • Cable:  3.65 m (12 ft.)
  • Environmental Conditions:
    • Operating Temperature:  -18–57 °C (0–135 °F)
    • Storage Temperature:  -29–74 °C (-20–165 °F)
    • Relative Humidity:  0–95%
  • Power Requirements:  11–52 Vdc phantom, 2.0 mA
Black Omnidirectional Replacement Cartridge
Shure R183B Black Omnidirectional Replacement Cartridge
Omnidirectional cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 and WL183 microphones.
Supercardioid Cartridge, Black.
Shure R184B Supercardioid Cartridge, Black.
Supercardioid cartridge for WL183, WL184, WL185 and all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 Microphones. 
Cardioid Cartridge, Black.
Shure R185B Cardioid Cartridge, Black.
Cardioid cartridge for all Microflex MX183, MX202, MX391, MX392, MX393, MX412, MX418 microphones.
Shockmount systems
Shure A400SM Shockmount systems
Recessed shock mount for all Microflex® and Easyflex® gooseneck microphones.The A400SM Shock Mount employs Shure Shock-Stopper TM construction, which decouples the microphone from the mounting surface and reduces the transmission of ...
Snap-Fit Windscreen (4-pack)
Shure RK412WS Snap-Fit Windscreen (4-pack)
The Shure RK412WS is a 4-pack of Snap-fit windscreens for MX412 and MX418.
Windscreen for SM99
Shure A99WS Windscreen for SM99
Large high performance foam windscreen for SM99 and MX400 Series gooseneck microphones.
Locking Metal Windscreen
Shure A412MWS Locking Metal Windscreen
The Shure A412MWS is a locking metal windscreen for Microflex gooseneck microphones.

Usually ships in 7-14 business days.
Need it sooner? Call us!
Add to Cart

We're sorry, only of this item available



Call a Sales Pro at for more information

Serving Contractors, Dealers, and Installers Since 1977

Contact: 1-800-828-0509 / Hours: Mon - Fri 7:00AM - 7:00PM